Remove debug leftovers that were causing memory corruption.
Writes of 64 or more bytes from the USB host side caused memory
corruption before this commit.
I've tested it in a STM32L4 board and it is working as expected.
115200 is a much more sane "default" than 38400.
Instead of a mix of 38400 and 115200, just use 115200 in all places.
There's no reason for modern 32bit cpus to be using such old slow
baudrates.
Tested on f1, f4, l1. Replaced some old f1 code that predated some
library support code for this.
HSI is out of spec for reliable USB operation, even though it sometimes
works. stm32-h103 board has an 8Mhz external crystal which should
therefore be used for any USB work.
Originally reported as https://github.com/libopencm3/libopencm3-examples/pull/192
This example was functionally similar to the "other" example, but had
the actual functional mouse movement disabled. To reduce maintennance
cost with slightly divergent examples, simply drop the less useful
example.
Using GPIOA_IDR directly looks a bit arcane, and the example can benefit
from introducing gpio_get() and how to use it. The stm32f0-discovery
example already does it like this.
Correctly migrate stm32f103_usb_driver to st_usbfs_v1_driver instead of the
f107 driver.
Fixes: 976720c355
Reviewed-by: Karl Palsson <karlp@tweak.net.au>
Be specifically careful with the usb examples. There is likely some
breakage to be expected, not sure I updated all the drivers to the
correct types for the respective chips.
As found in 6f2b39c1be6a8b9531264d92138dc2629d51cfa0, you can't just register a
control callback by itself, you can only register them in the set config
callback, (or, at least, _after_ set config has been done.
This has been compile tested only for the extra examples that were found to
have this failing pattern.
This has been broken since f87170e when set config started clearing control
handlers to be re-registered by different configurations.
Fix this example to use a set config callback to setup control transfer
callbacks, just like CDC-ACM demos. With this fix, this demo works with
dfu-tool 0.8
Signed-off-by: Karl Palsson <karlp@tweak.net.au>
Replace includes of stm32/YY/xxxx.h with stm32/xxxx.h
Replace stm32/YY/nvic.h with cm3/nvic.h.
In some cases, the include list was resorted alphabetically when it was
complicated and I was reviewing them manually, but most of this was
automatically done.
